Allen Elishewitz

The Ek integrals are back in stock on my website. If you missed out on the first run here is your chance to get one. #knifesales #ekcommando #dagger #edccarry #edccommunity #tacticalknives #fightingknife #combatknife

Heres an easy trick to support an object that doesnt have a completely straight or flat surface. My Phantom blades have a groove with a rim on the back of the blade. This blade is tapered and the only parallel surface is around the pivot. I use shim stock to support the blade during the surface g...

When you need to get the job done, you need the right tools. Behind the scenes: I cook breakfast everyday and today as I was trying to juggle cooking and adjusting sling/photo op, the frying pan was telling me its time to cookI have a Big little surprise for you guys tomorrow #vikingtactics #vtac...

Lots of MACV SOG options for @blade_show Come see them at booth 135#sog #macvsog #tacticalknife #combatknife #foldingknife #edc #everydaycarry

After grinding your chuck on your surface grinder you need to map out the chuck. This gives you an idea of the high and low spots. When I first got the grinder I ran a .00005 indicator across the entire chuck surface. I could only get so much information because of the graduations on the dial bei...

The Ek integrals just arrived and we are inspecting them. Unfortunately its so close to the Blade Show that we wont be able to put them on the website until after Atlanta. Well have them at the @blade_show at booth 135 though so stop by if you want one! #bladeshow #bladeshow2024 #knifesales #dag...

Had some spare time so I re-ground my magnetic chuck on the surface grinder. After grinding the base, I flipped the chuck over and sparked the stone on the surface. I ran the stone on the complete surface of the chuck, it was cutting heavier towards the back. It took an additional .00035 to clean...

Hope to see you guys @blade_show #knifeshow #atlanta #knives #tacticalknives #edc #everydaycarry

Fitting the locking bar to the blade using the @hardcore_products grinding and milling lock fixture. When you fit a lock I dont care if you fit the blade to locking bar or locking bar to blade, its a constant chasing of angles. Dont think once you got your angle set itll work for all the other kn...

The name Deka speaks for a decade of true American grit and passion behind every knife weve built. These ABLE Lock folders encompass the defining qualities one would want out of an everyday carry - MagnaCut blade steel, featherlight weight, and fully ambidextrous operation, from dual thumb studs ...

Yesterday I finished making the composite G10 handle for the SOG-PFC. Ill show you guys this new model next week when I get farther along on the build. #macvsog #combatknife #fightingknife #edc #everydaycarry #pocketknife #handmadeknife

Working towards @blade_show making more composite G-10 handles. These are for the new version of the MACV-SOG which is smaller. #bladeshow #bladeshow2024 #knifemaking #g10 #macvsog #foldingknife #tacticalknife #fightingknife